Ladder trays and covers supported segregated cable routes inside a data center.
The customer’s challenge
Long spans deflected excessively, covers loosened, and bonding between tray sections was unreliable.
Material and fabrication route
1.5 mm galvanized steel; stainless connectors.
Process route: Laser cutting → bending → welding → hot-dip galvanizing → assembly → load inspection.
Manufacturing changes
Side stiffeners increased rigidity, revised clips secured the covers, and bonding jumpers connected each section.
Engineering analysis
Span, load and deflection describe a connected structural condition. The reported load figure should be read with the stated support span and deflection criterion, rather than used as an unrestricted rating at any distance. The cover clips and bonding jumpers addressed different failure modes from tray bending. Together, these changes supported both mechanical installation and the continuity checks required by the project.
Inspection and project results
Deflection met the L/200 project limit, covers stayed secure, and continuity checks supported data-center acceptance.
| Project measurement or production detail | Recorded value |
|---|---|
| Deflection | ≤L/200 |
| Span | ≤2 m |
| Load test | ≥100 kg/m |
| Grounding resistance | ≤0.1 Ω |
These figures describe the project configuration and production scope above. Dimensional, material and production details are identified separately from performance tests. For a new order, the inspection method and acceptance criteria should be agreed against the released drawings.
Planning a similar OEM component
A useful RFQ for this application should make the following interfaces and acceptance requirements clear:
- Tray span and support positions.
- Distributed and local cable loads.
- Cover retention and access.
- Bonding interfaces and test points.
Include the current drawing revision, mating-component information, quantities and required delivery sequence. Identifying unresolved requirements at quotation stage helps distinguish fabrication work from the equipment-level checks that the project needs.
For related manufacturing support, review our Cable Tray and sheet metal quality capabilities. Use the existing quotation form below to share the drawing package for review.